Welcome to our resource for MG Car Information.
MG Midget and Sprite Technical - Engine Backplate Identification
| I have acquired an engine backplate with some 1275 engine parts. It's non-standard, I was wondering if anyone has seen one before and knows what it's from. It has some extra lumps and bumps, and also appears to have had a few pieces cut off. It is also about .090" thicker than a standard 1275 backplate. The oil pump cover is welded on. ![]() |
| Dave O'Neill 2 |
Looks a bit like Marina/Ital. I don't know if the 1.3 Maestro(?) had a backplate or not as I have never seen one. My photo (not found in a highly recommended book - due to space limitations. . ) is the Marina/Ital next to the 1275 Sprite/midget.
![]() |
| Daniel |
| There are some similarities, but the hole for the starter motor seems to be quite a bit lower on the Marina. I did think about Maestro, but I think they had an aluminium casting that went between engine and gearbox. |
| Dave O'Neill 2 |
| Apart from any other possible variations, I can't think of any form of A series blocks that have that large bulge beside the oil pump. So it must be there to match a gearbox bell housing. Automatic gearbox perhaps? |
| GuyW |
Maybe an adaptor plate to suit a Toyota T50 gearbox as images.
![]() ![]() |
| David Billington |
| Good call, Guy. David, that looks like a distinct possibility. |
| Dave O'Neill 2 |
| Didn't Frontline market a Toyota based 5 speed conversion kit for the Midget before they marketed a Ford Type 9 kit (using bell housing from the Morris Minor Centre Birmingham)? If they did it was without using the Australian Dellow bellhousing that was originally imported to the UK by Rooster Racing but by using a backplate. I might even have an old leaflet that shows that (among lots of other papers. . . so not easily found). |
| Daniel |
This thread was discussed between 07/10/2026 and 12/10/2026
MG Midget and Sprite Technical index
This thread is from the archive. The Live MG Midget and Sprite Technical BBS is active now.