Welcome to our resource for MG Car Information.
MG Midget and Sprite Technical - MX5 seats
| Finally got round to installing some mx5 seats that have been sat in the garage for about a year.
The aim was to get them as low as possible. Ive cut the bulge out the base of the pan and trimmed the foam to suit. After modifying the runners the seats are just about sitting flush on the floor. there is about 2mm clearance to allow them to slide, not that sliding was ever a must have. The drivers seat is tight to the transmission tunnel to get a better alignment with the steering wheel. The passenger seat is fitted more centrally. Ive also trimmed some foam from the lower back of the drivers seat. Going to get them finished in black leatherette with fluted punched centres. Taking the seats to JKraft Autotrim in Stone where Jack has done excellent work for me previously. ![]() ![]() |
| S Macfarlane |
| Looking forward to seeing the finished result! Out of interest which Mark/Year MX5 did the seats come from? |
| Tim C |
| They are early seats with the detachable headrests |
| S Macfarlane |
This thread was discussed on 11/10/2026
MG Midget and Sprite Technical index
This thread is from the archive. The Live MG Midget and Sprite Technical BBS is active now.