Welcome to our resource for MG Car Information.
|
MG Midget and Sprite Technical - Vacuum engine port
Hi folks, I've decided to fit a remote brake servo to our 1970 (1275) midget. The instructions state it should be connected to a suitable blanking plug (vacuum port) on the engine block. Any ideas where this is located? Much appreciated Darren |
D Jones |
Yes it will be on the inlet manifold. |
Bob (robert) Midget Turbo |
Inlet manifold. Don't forget the one way valve as protection against the vacuum sucking out your brake fluid if the servo seals go. The first time i din't bother until i had a big cloud of white smoke & no brakes going into a corner, doh! Brad |
B Richards |
This thread was discussed on 21/08/2008
MG Midget and Sprite Technical index
This thread is from the archive. The Live MG Midget and Sprite Technical BBS is active now.