Welcome to our resource for MG Car Information.
MG MGA - brake luid question
| I topped up my master cylinder the other day after bleeding the rear beakes. I used DOT4 instead of DOT3 and was wondering if this would cause a problem. The container says it is compatable with DOT3. If I need to change it what would be the best way? Thanks Kris |
| Kris Sorensen |
| Kris - Dot 3 and DOT 4 are basically the same fluid except that DOT 4 is compounded to be low moisture absorbtion. The boiling point of DOT 3 tends to be a bit higher when it is wet than with DOT 4. For normal driving, you should experience no problems with the two mixed. Cheers - Dave |
| David DuBois |
This thread was discussed on 30/04/2005
MG MGA index
This thread is from the archive. The Live MG MGA BBS is active now.