Welcome to our resource for MG Car Information.
MG MGA - Exhaust manifold
|I am replacing the exhaust manifold on a 1957 MGA. I think the torque is 25ft/pounds but I have not been able to get the sequence. Does it matter? I was going to start and the middle and work out towards the ends. Does that seem logical?|
|Doesn't matter much, only six studs, just tighten them all down evenly a little bit at a time.|
|And remember that the bracket for the vacuum pipe/gas trap fits under the rear manifold nut.|
|Second stud from the back for originality, but you have to be a it of a masochist to do it as original.|
This thread was discussed between 08/02/2011 and 09/02/2011
MG MGA index
This thread is from the archive. The Live MG MGA BBS is active now.