Welcome to our resource for MG Car Information.
|
MG MGA - Heater--water valve
Hi to all, just trying to fit the dash and heater controls and can't find where the water valve cable for the heater goes through the bulkhead. Help please. Steve A. |
S Ash |
http://mgaguru.com/mgtech/body/bd105.htm |
R J Brown |
Thanks RJ,I have already looked at that but as far as I can see it only shows the cable holes on the bulkhead for the air flap at the bottom of the heater casing and for the large intake tube at the top, which are controlled by the two knobs each side of the central facia.The cable that attaches to the water valve at the engine end and the heater fan switch control behind the facia does not seem to be shown.(three cable control holes) Steve A |
S Ash |
Steve It's No. 7 on the diagram. Steve |
Steve Gyles |
Steve See attached. Steve |
Steve Gyles |
Steve G. If No-7 is for the water valve and N0-21 is the air control, where does the other one go through the bulkhead? Steve A. |
S Ash |
Steve, The control cable for the air flap on the bottom of the heater does not go through the bulkhead. All components are inside the cabin. Tony |
A M Leyva |
Tony L, Thanks,as I have not yet installed the heater box I couldn't work out where the controls went.A senior moment. Regards, Steve A |
S Ash |
This thread was discussed on 19/11/2011
MG MGA index
This thread is from the archive. The Live MG MGA BBS is active now.