Welcome to our resource for MG Car Information.
|
MG MGA - Input Shaft Movement
I purchased the Five Speed Sierra gearbox. While preparing to shorten the clutch release guide sleeve, I noticed the input shaft has some movement from side to side/up and down. The movement is about 2mm to 2.5mm with the clutch release bearing guide sleeve removed. This was measured with a pointer attached to the most forward end of the input shaft. Is this amount of movement acceptable? |
Ray Ammeter |
Some movement is normal, the pilot bearing in the end of the crankshaft supports the shaft when the trans is installed. Your movement does not seem excessive. |
J Heisenfeldt |
This thread was discussed between 21/01/2008 and 22/01/2008
MG MGA index
This thread is from the archive. The Live MG MGA BBS is active now.