MG-Cars.net

Welcome to our resource for MG Car Information.

Recommendations

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGA - Length of middle wiper tube

Could someone measure the length of the middle wiper tube (if they have one sitting around, as difficult insitu). I have a couple of spares, but they seem too long to fit in the connections at the end of the wiper wheelbox.
Gary Lock

Gary

No takers but you could get a good approximation by measuring the centres of the wiper holes in the scuttle and subtracting the centre to flange distances of the wiper boxes. I can measure a wiper box if you wish.

Sufficient to eliminate or confirm your spares.

Cheers

Dave
Bolney Coupe

Gary

The length of tube after flaring is 348mm. The attached image shows the degree of bend and by referencing the the straight edge the offset at the centre is circa 15mm.
Hope this helps
Regards
Mark


M Dollimore

Gary, I have measured the tube on my car as best I could from underneath and it seems to be 346 mm.

Hope that helps,

Cheers
Colyn
Colyn Firth

I think there is probably some variance here. I put a NOS tube in about three weeks ago, and it is a fraction too long to be a perfect fit.
Dominic Clancy

Thanks guys. The NOS (?) ones are impossible to fit in the correct slots in the wiper boxes...or one end does, but the other is about 1cm too long. Barney says that the flared parts should fit in the outer slots. Looks like some cutting and re-flaring to be done.
Gary Lock

Too long? Bend it a little more.
barneymg

I was taking a look at the wiper gearboxes under the dash yesterday when I measured the distance tube in situ and I did wonder if bending it would make it fit.

But the gearboxes would each then have to be rotated a little more to line up with the tube ends and with not much light and at arms length, I just couldn't make out if the mounting holes would allow for this.

Colyn
Colyn Firth

If a little additional bend is not enough, then cut the end off and re-flare it.
barneymg

This thread was discussed between 03/03/2018 and 05/03/2018

MG MGA index

This thread is from the archive. The Live MG MGA BBS is active now.