Welcome to our resource for MG Car Information.
|
MG MGA - Rewiring MGA
I am in the middle of refurbishing my MGA, but I've hit a snag - it seems like ages ago that I stripped out the old front and rear lighting looms, and I can't figure out where to attach the new ones to the bodywork. For example, does the rear one sit inside the boot compartment, or is it slung underneath? Same sort of question for the front one? Next time, I really must take better notes! |
Robert Sinclair |
Robert Barney has a lot on his site. This is the elctrical section: http://www.mgaguru.com/mgtech/electric/electr_2.htm On this index page he also has a bit on the wiring loom: http://www.mgaguru.com/mgtech/electric/harness.htm Steve |
Steve Gyles |
Wow. Too much to remember on my web site. It has been a long time since I looked at that last page. It has a a few minor errors or omissions, and I may delete the page rather than revising it. There are better harness installation instructions here: http://mgaguru.com/mgtech/electric/electr_1.htm http://mgaguru.com/mgtech/electric/et100a.htm http://mgaguru.com/mgtech/electric/et100b.htm http://mgaguru.com/mgtech/electric/circ_a.htm If you are doing a 1600 there are a few minor changes for the dash connections related to the turn signal switch, easy to find in the wiring diagrams. A Twin Cam has the ignition coil wire(s) running to the opposite side of the engine bay, forward from the wiper motor. |
Barney Gaylord |
This thread was discussed on 11/12/2006
MG MGA index
This thread is from the archive. The Live MG MGA BBS is active now.