Welcome to our resource for MG Car Information.
|
MG MGA - Valve Caps and Collets
Does anyone have any original caps and collets available from a later 1800 engine? I'm putting some 1.625" inlet valves into a Derrington Head and the collets and caps from the smaller valves I have won't fit the bigger valves. Apparently the ones that are available new are not very good compared to original ones. On a flow rig the flow through the original 1.560" valves has been measured at 78.2CFM with 0.400" lift. With a similar head with 1.620" valves the flow is 89.7CFM which is good improvement. Thanks John |
John Francis |
This thread was discussed on 20/02/2012
MG MGA index
This thread is from the archive. The Live MG MGA BBS is active now.