Welcome to our resource for MG Car Information.
MG TD TF 1500 - Why I like LEDs part deux
I switched out the incandescent bulbs for LED in the fog lights on my 51 TD. As you can see the current draw is minimal with the LEDs. This isn't about providing extra capacity for the generator or adding high wattage accessories. It is about reducing wear and tear on the electrical components, especially the switches, on the car. https://www.youtube.com/watch?v=S2hcl85n3fA Tim |
Timothy Burchfield |
Does someone supply led bulbs in positive earth for the Lucas SFT 576 and WLR 576 accessory lamps that were common in the 50s and 60s? |
John Quilter (TD8986) |
John, go to this page. http://www.dynamoregulatorconversions.com/led-headlamp-bulbs-shop.php Check out the section, "Single Filament Equivalent Headlamp Bulbs" I bought these bulbs for my SFT fog lamps. https://www.ebay.com/itm/2x-P36S-BPF-P323-Lucas-LLB323-45W-CREE-LED-Fog-Light-Spotlight-Bulb-White-12V/221382343478?hash=item338b6a7b36:g:SnMAAOSw~bFWGLwa They don't specify the polarity but they work with my negative ground car. Tim |
Timothy Burchfield |
John,just got a message back from the Ebay seller. they only have negative earth bulbs. Tim |
Timothy Burchfield |
That's strange. These ones look similar and work with the SFT 462 lamps on my positive ground TD: https://www.ebay.co.uk/itm/2x-45W-CREE-LED-LUCAS-LLB323-SPOTLIGHT-FOG-LIGHT-BULBS-12v-P36s-SFT576-SFT700/323193231550?hash=item4b3fd158be:g:oDkAAOSw4SlV7jjW. Polarity isn't mentioned in the listing and I think they could actually be designed to fit both positive and negative. Tim TD 1580 |
Tim Wilkinson |
Tim W, they look identical to the bulbs I have. The Cree numbers are the same. As I said the seller of the bulbs I bought replied that they only came in negative ground. I was under the impression that LED were earth sensitive. But perhaps they are making LEDs that can be installed on positive or negative ground cars. I asked your seller if his bulbs come in positive ground. I'll report back if I get an answer. Regards Tim |
Timothy Burchfield |
You're right of course, LEDs are certainly polarity sensitive, but I imagine they could be designed with a diode bridge to connect either polarity. Tim TD 1580 |
Tim Wilkinson |
I checked with the Ebay vendor in Timothy Burchfield's post above and received a response they are only for negative ground. So I await some vendor to offer them in positive ground. |
John Quilter (TD8986) |
John, did you contact http://www.dynamoregulatorconversions.com/led-headlamp-bulbs-shop.php Tim |
Timothy Burchfield |
Yes thanks, a response from this vendor indicates that item number 3 on this link is suitable for positive ground. http://www.dynamoregulatorconversions.com/stop-lamp-bulbs-21w-shop.php |
John Quilter (TD8986) |
Have you checked out Paul Goff aka Norbsa 's stuff? Lot little LED stuff. |
kylemorley |
Or the exact fit LED light boards at www.brittrix.com USA designed and manufactured |
Lew Palmer |
This thread was discussed between 03/07/2018 and 12/07/2018
MG TD TF 1500 index
This thread is from the archive. The Live MG TD TF 1500 BBS is active now.